 |
ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
 flexsim.com |
|
||||||
| Downloads |
| Flexsim Student Forum Forum for discussion for Flexsim Students using the Flexsim Textbook. |
|
#1
04-19-2015
|
|||
|
|||
how to move the pairwise
currently, the item move to Queen singly (by operator port 2, port 3)
i wonder that the item move to Queen pairwise by operator |
|
#2
04-20-2015
|
|||
|
|||
|
how to move the pairwise
Please,
Clarify your doubt a little bit more to help you. Actually, what the operator is doing is separating the content(item), since the item is the pallet that you set to be created by Source3. The operator in your model is just separating the entire contents (box) since you are returning content(item). Thanks,
__________________
Michael Machado - FlexSim Brasil |
| The Following User Says Thank You to mefhsmflexsimbr For This Useful Post: | ||
Jörg Vogel (04-20-2015) | ||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to move a connection up or down using a command? | mearjun | Q&A | 2 | 10-03-2014 02:26 PM |
| how could I get opeartors move during processing? | zoeygollum | Q&A | 4 | 07-17-2010 01:06 AM |
| why the BasicTE can not move? | LINWEIXU | Q&A | 0 | 08-14-2009 09:24 PM |
| Continuously Move | Li Chin | Q&A | 12 | 10-13-2008 03:49 AM |
| Crane Move | Sung Kim | Q&A | 2 | 06-05-2008 03:03 PM |
