ATTENTION

#1 03-09-2016

Hi!

Just a quick question. I want a TaskExecuter to be available for every 5 minutes.
For instance, it will only start with doing the first tasksequence 5 minutes after the simulation starts. Then, it goes back into an idle state (again, for 5 minutes) before doing the next tasksequence. How can I do it?

#2 03-09-2016

Hi Lester,

Sounds like using timetables would be the best option for you. Add one from the toolbox and set the desired down state times.

Axel

Thread	Thread Starter	Forum	Replies	Last Post
Writing to Shift Schedule Table	michaelsmith	FlexSim HC: Q&A	1	04-23-2015 03:34 PM
How to transfer a flowitem from a taskexecuter-team to another taskexecuter-team?	Frans Zeng	Q&A	12	05-20-2010 11:23 PM
Release schedule	Roland Tainton	Q&A	3	03-17-2009 05:46 AM
Arrival schedule Source	Nico Zahn	Q&A	3	12-15-2008 04:23 AM
Import of data in schedule of a source	Matthias Hofmann	Q&A	3	10-07-2008 09:30 AM

The Following 2 Users Say Thank You to Axel Kohonen For This Useful Post:
Sebastian Hemmann (03-09-2016)