ATTENTION

#1 11-07-2014

Hi all.

I am working on a model with a rather abundant number of conveyors.

To make this easier, I am working on getting them to automatically reposition themselves to match the positions and angles their respective inobjects. I have tried looking for the endpoint coordinates and angle in the tree of the conveyor, but so far unsuccessfully.

Are there any flexscript functions that deal with this, or do I have to write the code from scratch?

Best regards
Christian

#2 11-07-2014

By the way - When I get the section location data from the path, >variables/sections/sectionX/startx and
>variables/sections/sectionX/starty
the resulting coordinates seem to be a little bit off.

#3 11-07-2014

Here is a thread to modify section to conveyor using flexscript functions
https://www.flexsim.com/community/fo...ead.php?t=1395

#4 11-07-2014

If you hold the X key and click a Conveyor, it will align the next conveyor through its first output port to the end of it.

Thread	Thread Starter	Forum	Replies	Last Post
What is the difference between a Conveyor and Basic Conveyor	shivrash	Q&A	2	07-21-2009 04:09 AM

The Following User Says Thank You to sagar bolisetti For This Useful Post:
Christian Norregaard (11-07-2014)

The Following 2 Users Say Thank You to Phil BoBo For This Useful Post:
sagar bolisetti (11-07-2014)