Question about Experimenter

I have a relatively simple question.
I have designed multiple scenarios is Experimenter. I have set a warm-up time. I also checked the 'save the state after each model run' option. I run it and collect results.
Now if I load one of these states onto the model and generate a report using 'Report and Statistics' option, does it exclude the statistics from the Warm-up period? If not then what would be the way forward? I am looking to collect stats related to different states that a multiprocessor goes into but only after the model has been warmed-up.

Hi Arjun,

The following thread may help you.

http://www.flexsim.com/community/for...read.php?t=735

Regards,

Arun

Thanks for responding but the link didn't help much. Only confused me more !

If you don't know, perhaps you can try to build a small model and test it. To test the behavior of the warmup time in the experimenter, build a very simple model wherein a processor is processing 200 time units and then 100 time units is idle. Then you use the experimenter with one scenario and one replication and a warmup time of 100. Run the model and check the results. You can interpret the results by yourself and you know what is to know. And you vary this model to get more knowledge what the saved replication results contain.
Jörg

Thanks for responding but the link didn't help much. Only confused me more !

What you confuse is a different Version of Flexsim, when the answer was written. Sometimes the Developers introduce a feature and it disappears in later versions again. This is Development.
Jörg