ATTENTION

#1 11-26-2010

Hi, i build a test modell with some coordinated task sequences.
It works fine so far, but it stops after 5 transports are executed.
It seems that the queue can not find an aim for the items and stopps generating the task sequences. I tried a pull on the processors and a resume on downstream availablity on the queue but this did not help...
Can someone give some advice how to get this working?

#2 11-26-2010

Chang the Unload task to FRUNLOAD and it works fine.

I'm not sure exactly the reasons behind it but using only UNLOAD doesn't appear to tell the machines they have actually had a part and their input ports do not open up again hence you only get one cycle through each.

Anth

Thread	Thread Starter	Forum	Replies	Last Post
Problems with load/ unload tasksequences	Sebastian Hemmann	Q&A	7	11-19-2009 12:58 AM
About Coordinated Task Sequences	Normand Côté	Gripes and Goodies	1	06-21-2008 06:08 AM
coordinated task sequence, need help.	qin tian	Q&A	4	05-12-2008 05:52 PM
Tasksequences	Simon Farsah	Q&A	2	04-28-2008 01:52 PM
Queuing coordinated task sequences?	Nico Zahn	Q&A	19	04-02-2008 08:30 AM

The Following 2 Users Say Thank You to Anthony Timmiss For This Useful Post:
Phil BoBo (11-29-2010)