ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.
flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Gripes and Goodies
Reload this Page Combiner Features
Downloads

Gripes and Goodies Software problems and suggestions

  #1  
Old 05-12-2010
michaelsmith michaelsmith is offline
TMN Simulation -Australia
  
Join Date: Aug 2007
Location: Hobart Tasmania
Posts: 62
Downloads: 7
Uploads: 0
Thanks: 31
Thanked 19 Times in 12 Posts
Rep Power: 170
michaelsmith will become famous soon enough
Default Combiner Features
I am still using 4.5 so sorry if this has been captured in V5.

When using a combiner it would be good to have a simpler Update Component List trigger and possibly include it in the On reset List.

Probably in a similar way to the send to port triggers where you can specify a number or ref to table/label etc against each port.


Thread Thread Starter Forum Replies Last Post
Combiner problem Angie Williamson Q&A 6 04-21-2010 09:04 AM
Releasing to a Combiner Alistair Smitheman Q&A 7 05-15-2009 04:04 AM
a combiner question Vic Li Q&A 2 08-19-2008 03:42 AM
Combiner problem Simon Farsah Q&A 4 05-29-2008 06:34 AM
I want flexsim to provide the features for the lean system... syseo Gripes and Goodies 2 05-23-2008 07:45 PM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.