ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 10-29-2008
Paul Dowling Paul Dowling is offline
Flexsim User
 
Join Date: Aug 2007
Location: Sydney, Australia
Posts: 42
Downloads: 14
Uploads: 0
Thanks: 12
Thanked 4 Times in 4 Posts
Rep Power: 161
Paul Dowling is on a distinguished road
Default Conveyor with Acceleration/ Deceleration

Hi All,

I have setup a standard conveyor to implement acceleration and deceleration and thought i might put it up for feedback (is this how others would do it?). Nothing spectacular, but serves my purposes thus far.

How to use it:
===========
- Acceleration and Decceleration rates set as labels in conveyor
- Change speed by sending a message with msgparam(1) = 1 and msgparam(2) = desired speed to conveyor. Will then change according to defined acc/dec rates

Regards
Paul

PS- Know a basic conveyor has this functionality, but I don't need a lot of the other things implemented, thus this might run faster...?
Attached Files
File Type: zip AccDecConveyor.zip (53.0 KB, 297 views)
The Following User Says Thank You to Paul Dowling For This Useful Post:
Pablo Concha (10-30-2008)


Thread Thread Starter Forum Replies Last Post
Standard Operator speed/ acceleration/ decelleration Paul Dowling Q&A 0 06-18-2008 09:24 PM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.