ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 08-27-2008
Martijn van Oostenbrugge's Avatar
Martijn van Oostenbrugge Martijn van Oostenbrugge is offline
Talumis, Flexsim Distributor, The Netherlands
 
Join Date: Aug 2007
Posts: 71
Downloads: 12
Uploads: 0
Thanks: 44
Thanked 44 Times in 24 Posts
Rep Power: 268
Martijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to all
Default Processor

Again, during a course I run into the setup time of a general processor. If I look at the flexscript code it has three declarations of which the port definition is declared as a treenode. This should be an integer. Flexscript interprets it correctly, so there seems to be no problem. It's just a note that it's declared as a treenode. This is also the same on the Combiner/Separator.

Martijn
The Following User Says Thank You to Martijn van Oostenbrugge For This Useful Post:
Jörg Vogel (08-28-2008)


Thread Thread Starter Forum Replies Last Post
Sequence of Flow Items Through a Processor Anthony Timmiss Q&A 0 06-11-2008 02:26 AM
Changing the height that a Transporter drops off an item to a Processor KelvinHo Q&A 1 04-10-2008 09:29 AM
Changing the direction of flowitem movement on a processor shivrash Q&A 3 04-09-2008 10:31 PM
Problem with Processor Output avinash Q&A 2 03-26-2008 09:19 AM
Multi-Processor Help Davie Stomp Q&A 3 01-27-2008 02:23 PM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.