 |
ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
 flexsim.com |
|
#1
05-19-2008
|
||||
|
||||
Operators moving backwards
Hi, I had a modell where all the TE were moving backwards because of two missing nodes. The modell was migrated from some older versions and usualy those nodes are added automatically but in this case it didn´t work.
So heres is a small use command which will add those two missing nodes in all the TE in the model if they don´t exist (kinematics , flipthreshold). 
__________________
kind regards Nico. |
| The Following 2 Users Say Thank You to Nico Zahn For This Useful Post: | ||
RalfGruber (06-05-2008) | ||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to model operators' efficiency? | Liu Bin | Q&A | 4 | 05-21-2008 07:56 AM |
| Moving Network Node Information into a Table | Brandon Peterson | Q&A | 2 | 02-15-2008 09:46 AM |
| Setting the number of operators | Sung Kim | Q&A | 4 | 02-05-2008 12:31 PM |
| Operators on Multiple Networks | Nico Zahn | Q&A | 0 | 10-10-2007 03:02 AM |
| Controlling the camera view to be focused on a moving object in your model. | Regan Blackett | Tips and Tricks | 0 | 08-03-2007 10:12 AM |
