Running two or more parts side by side on the conveyor

		FlexSim Community Forum > FlexSim Software > Q&A
Running two or more parts side by side on the conveyor

Downloads

Q&A Using Flexsim and building models

11-16-2015

David Chan David Chan is offline

Flexsim Distributor

Join Date: Sep 2007

Posts: 326

Downloads: 74

Uploads: 0

Thanks: 217

Thanked 73 Times in 44 Posts

Rep Power: 218

Running two or more parts side by side on the conveyor

Hi

I would like to find out if we can run two or more parts side by side on the conveyor. I know I can use two or more conveyors and place them side by side. I wonder if it is possible to do it on one conveyor.

Also the end of the conveyor is a lift where parts enters to the lift and lifted to up to another conveyor. If I am using two conveyors, it will difficult for both parts going into the lift at the same time.

Any advise?

__________________
Advent2 Labs

David

Tags

conveyor, side_by_side

Thread	Thread Starter	Forum	Replies	Last Post
Combiner / getting all parts in a batch	Marco Bergmann	Q&A	8	12-02-2013 10:07 AM
Getting parts from three conveyors in our defined order	Radhakrishnan R	Q&A	6	10-16-2012 03:11 AM
Receiving parts with respect to its itemtype	Radhakrishnan R	Q&A	3	09-10-2012 01:33 AM
Setting the side offset for all nodes in the model	Brandon Peterson	Tips and Tricks	0	04-28-2008 11:15 AM
about "no select" and "show parameter window from side bar"	qin tian	Gripes and Goodies	3	03-21-2008 08:10 AM

All times are GMT -6.