Repair Operator

I seems not able to get repair operator working. I have set-up the MTBF/MTTR, I have checked to use Repair Operator. However the repair operator is triggered during the down time with 4.01 and 4.3.

Also when I click State list, I think the GUI gave me the MTBF GUI again.

Anyone have any idea?

David

Further discovery.

I found that by using the MTBF/MTTR from the toolbox, you can't trigger the Repair operator. You have to use "Processor MTBF MTTR" on the Processor Time Parameter page, where you will need to enter the same information as the MTBF/MTTR from the toolbox then you can trigger the repair operator.

But why? Is the code disconnected code from using MTBF/MTTR from the toolbox to trigger the operator?