 |
ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
 flexsim.com |
|
#1
02-10-2012
|
|||
|
|||
using layout with visual tool
hi all,
I've created a model with a layout drawing in it. The layout has been imported in a DXF file format (with origin as its coordinates) using visual tool. When I try to open the model in any other pc and take the source file also (i.e.., the dxf file) along with it.... The model is alright but the layout is not being seen... How do I get access to the layout??? What can I do to overcome this trouble.... thanks, naveen kumar.p |
|
#2
02-10-2012
|
|||
|
|||
|
Hi
the layout was on a visual tool?. if so, just open the visual tool properties from the treeview and update the location of the .dxf file regards Pablo |
| The Following User Says Thank You to Pablo Concha For This Useful Post: | ||
naveenkumar (02-10-2012) | ||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Visual Tool Text Wrapping | Todd Benanzer | Q&A | 2 | 12-17-2010 10:30 AM |
| Put GlobalTable into Visual Tool | claudia gertheinrich | Q&A | 3 | 03-25-2010 04:04 AM |
| Sum in a Visual Tool | jspeece | Q&A | 3 | 09-04-2009 11:31 AM |
| how to make the visual tool transparent? | qin tian | Q&A | 8 | 11-28-2008 11:17 AM |
| Visual tool as a container qs | Paul Dowling | Q&A | 2 | 08-20-2007 07:53 PM |
