ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
flexsim.com |
#1
|
|||
|
|||
Using labels
Hello everyone,
In my model one of the machines is a separator, which is used to separate the entry part to subparts.On each subpart I need to assign a label starting from 1 and incrementing on the following subparts. That way I can keep track on the subparts down the road. If anyone has an idea how I could incorporate this into my model that would be greatly appreciated. Thanks in advance, Mike |
#2
|
|||
|
|||
You could have a label on the separator whose value you assign to the parts you output. Every time you assign the value to the parts you would also increment the the label value on the separator by one.
If you need to set it you could also check that if it equals a particular value you could reset it to your start value. |
The Following User Says Thank You to Anthony Timmiss For This Useful Post: | ||
m matias (03-02-2010) |
Thread | Thread Starter | Forum | Replies | Last Post |
Edit Labels Model Control GUI | Phil BoBo | Tips and Tricks | 1 | 10-21-2011 12:30 PM |
different labels have different delay time | Vic Li | Q&A | 5 | 09-22-2008 04:21 AM |
Updating Labels | Alexandre Ouellet | Q&A | 2 | 04-02-2008 06:55 AM |
Updating Labels | Naresh Yamani | Q&A | 7 | 03-28-2008 11:28 PM |
Display Labels with the Recorder | tsconcept | Q&A | 9 | 09-26-2007 08:16 AM |