ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 03-09-2016
Lester Antonni Hesita
Guest
 
Posts: n/a
Downloads: 0
Uploads: 0
Default Schedule Use of TaskExecuter

Hi!

Just a quick question. I want a TaskExecuter to be available for every 5 minutes.
For instance, it will only start with doing the first tasksequence 5 minutes after the simulation starts. Then, it goes back into an idle state (again, for 5 minutes) before doing the next tasksequence. How can I do it?
  #2  
Old 03-09-2016
Axel Kohonen
Guest
 
Posts: n/a
Downloads: 22
Uploads: 0
Default

Hi Lester,

Sounds like using timetables would be the best option for you. Add one from the toolbox and set the desired down state times.

Axel
The Following 2 Users Say Thank You to Axel Kohonen For This Useful Post:
Sebastian Hemmann (03-09-2016)

Tags
schedule, task executor


Thread Thread Starter Forum Replies Last Post
Writing to Shift Schedule Table michaelsmith FlexSim HC: Q&A 1 04-23-2015 03:34 PM
How to transfer a flowitem from a taskexecuter-team to another taskexecuter-team? Frans Zeng Q&A 12 05-20-2010 11:23 PM
Release schedule Roland Tainton Q&A 3 03-17-2009 05:46 AM
Arrival schedule Source Nico Zahn Q&A 3 12-15-2008 04:23 AM
Import of data in schedule of a source Matthias Hofmann Q&A 3 10-07-2008 09:30 AM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.