ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 03-16-2016
carlo timossi
Guest
 
Posts: n/a
Downloads: 1
Uploads: 0
Default Intercept the end of a travel of a task executer

Hi excuse me, how can intercept the end of a travel of a task executer?
I have a coordinated task sequence involving a crane and a task executer and it is important that after the dropping off of the 1st empty bucket from the crane, the task executer repositions itself in order to allow the crane (which cannot move on Y axis) to pick on the 2nd full bucket.
I've used a coordinated task sequence and after the dropping off task of the crane I've put a synchronization task with the crane operation, followed by the repositioning task of the task executer, after which I've put another synchronization task with the task executer repositioning and finally I've added the picking task of the crane.
Notwithstanding the syncronization task the crane makes the picking operation of the full bucket without waiting for the repositioning of the task executer.
Tanks very much in advance for Your support.
  #2  
Old 03-16-2016
RalfGruber's Avatar
RalfGruber RalfGruber is offline
FlexSim Software Products
 
Join Date: Jul 2007
Location: Orem, UT, USA
Posts: 195
Downloads: 37
Uploads: 0
Thanks: 518
Thanked 294 Times in 124 Posts
Rep Power: 345
RalfGruber is a splendid one to beholdRalfGruber is a splendid one to beholdRalfGruber is a splendid one to beholdRalfGruber is a splendid one to beholdRalfGruber is a splendid one to beholdRalfGruber is a splendid one to beholdRalfGruber is a splendid one to behold
Default

Carlo,

it would be much easier for the community to help if you were able to post your model. From what you are explaining the second synchronization does not work, but to figure out why we would need to see the model.

Thanks
Ralf
FlexSim
The Following User Says Thank You to RalfGruber For This Useful Post:
Jörg Vogel (03-17-2016)


Thread Thread Starter Forum Replies Last Post
Task Executer turns by 180 degrees when it arrives at a final node carlo timossi Q&A 3 03-04-2016 01:32 PM
Task executer running Free on Agv Network daniele baga Q&A 6 12-04-2014 10:44 AM
How to return a pointer to a task executer mearjun Flexsim Student Forum 18 05-06-2013 08:33 AM
A Task Executer should receive two tasksequence from dispatcher... syseo Q&A 10 07-14-2012 01:03 PM
task executer juan alberto Pre-sales Questions 1 06-01-2009 07:06 PM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.