ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Gripes and Goodies
Downloads

Gripes and Goodies Software problems and suggestions

  #1  
Old 09-29-2011
Martijn van Oostenbrugge's Avatar
Martijn van Oostenbrugge Martijn van Oostenbrugge is offline
Talumis, Flexsim Distributor, The Netherlands
 
Join Date: Aug 2007
Posts: 71
Downloads: 12
Uploads: 0
Thanks: 44
Thanked 44 Times in 24 Posts
Rep Power: 268
Martijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to allMartijn van Oostenbrugge is a name known to all
Default Tasktype Utilize

Just yesterday I used a tasktype utilize in my tasksequence (Flexsim 5.1). I usually just fill the task with all variables although they are not used in each tasktype. For the utilize task var2-var4 should be N/A. If you've put a non-zero value as a var2 value, the system console pops up with an error. Would be nice if it still works although you've filled in non used values.

Martijn


Thread Thread Starter Forum Replies Last Post
TASKTYPE NODEFUNCTION juan alberto Q&A 1 04-16-2010 03:19 AM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.