ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 04-09-2010
AlanZhang's Avatar
AlanZhang AlanZhang is offline
Flexsim Super Moderator
 
Join Date: Aug 2007
Location: CA
Posts: 289
Downloads: 64
Uploads: 0
Thanks: 88
Thanked 91 Times in 47 Posts
Rep Power: 225
AlanZhang is a jewel in the roughAlanZhang is a jewel in the roughAlanZhang is a jewel in the rough
Default viewtofile command is slow

Anybody experiences this problem? This command is used in the code of Generate Experiment Report. I found each picture will take about 7 to 8 seconds to be saved into a file. This makes Generate Experiment Report extremely slow as typically a bunch of pictures will be saved.

The command can be tested in a Script window simply by doing:
viewtofile(sv(), "c:/test.bmp")

If there is a workaround to this command, I would like to know.

Thanks very much!
__________________
Best,
Alan


Thread Thread Starter Forum Replies Last Post
family command? zhang xin Q&A 0 01-14-2010 06:33 PM
Problems with the command dbsqlquery Matthias Hofmann Q&A 4 11-21-2008 01:02 PM
Command getnextnetnodeoutport Martijn van Oostenbrugge Q&A 0 02-22-2008 05:42 AM
releaseitem command AlanZhang Q&A 3 10-04-2007 10:11 AM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.