 |
ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
 flexsim.com |
|
#1
10-18-2011
|
|||
|
|||
wrong location of Lifter in RTG
In the attached figure, I showed a case where the lifter part of RTG has magically jumped far away to drop s container on a transporter which in turn quite magically drives below the another stack.
Any comment is appreciated. |
|
#2
10-18-2011
|
||||
|
||||
|
When loading/unloading, the RTG's frame only travels along one directional axis. The trolley and hoist will go to the container you told it to load/unload whether it is under the RTG's frame or not.
Usually, when a trolly is reaching beyond the frame of its RTG, it is because the modeler assigned the wrong RTG to do the load/unload. Fix your Resource Assignment table. You should also connect your trucks to the network if you want them to travel on the network. Please refer to the introductory tutorials in the CT manual. |
| Thread | Thread Starter | Forum | Replies | Last Post |
| wrong location of RTG during simulation | Shahin Gelareh | Container Terminal (CT) Library | 2 | 09-30-2011 02:01 AM |
| each item has it's given location,and item's code correspond to storage location | Robert Liu | Q&A | 3 | 03-28-2011 08:46 PM |
| How to find where goes wrong quickly | john mic | Q&A | 2 | 11-03-2010 10:06 AM |
| some thing wrong with kinematics | LINWEIXU | Q&A | 7 | 11-28-2009 05:34 AM |
| what is wrong my model | LINWEIXU | Q&A | 7 | 08-17-2009 10:50 PM |
