ATTENTION

#1 09-29-2011

Hi,

I am new here and perhaps some of my questions look ... .
I have made terminal layout and all the componets needed for my work. There is an RTG allocated to every individual block which is set in the resource assignment part of yard planner.
When I run the model I see that the RTG are displaced to wrong locations --- not remainin in the relevant block they must be.

I appreciate any comment on it.

regards,

#2 09-29-2011

Your Resource Assignment table is set up incorrectly. If you would post your model, it would be easier to tell you specifics.

#3 09-30-2011

Thanks for reply. yes I checked again.

Thread	Thread Starter	Forum	Replies	Last Post
Wrong Fluid Object Tutorial	Sebastian Hemmann	Q&A	2	08-30-2011 09:51 AM
each item has it's given location,and item's code correspond to storage location	Robert Liu	Q&A	3	03-28-2011 08:46 PM
How to find where goes wrong quickly	john mic	Q&A	2	11-03-2010 10:06 AM
some thing wrong with kinematics	LINWEIXU	Q&A	7	11-28-2009 05:34 AM
what is wrong my model	LINWEIXU	Q&A	7	08-17-2009 10:50 PM

The Following User Says Thank You to Phil BoBo For This Useful Post:
Shahin Gelareh (09-30-2011)