ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
Downloads

Q&A Using Flexsim and building models

  #1  
Old 03-31-2013
LINWEIXU
Guest
 
Posts: n/a
Downloads:
Uploads:
Default what mean "LINK PARITY ERROR(step)"

the syetem console print "LINK PARITY ERROR(step)",i do not know what is it mean?what cause the problem?
  #2  
Old 04-01-2013
Phil BoBo's Avatar
Phil BoBo Phil BoBo is offline
Flexsim Development
 
Join Date: Jan 2008
Posts: 756
Downloads: 109
Uploads: 18
Thanks: 385
Thanked 1,483 Times in 525 Posts
Rep Power: 1174
Phil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond reputePhil BoBo has a reputation beyond repute
Default

A link parity error is printed when a node is referenced but it doesn't exist anymore. The note of "step" means that it was referenced by rank by the parent node. There are hundreds of places that we reference nodes like this.

The best way to figure out what is causing it is to find the line of code that prints it and see what that line of code is doing.

If it happens while you are running a model, find the event that causes it, then step through the code in that event to find the exact line that causes the error to be printed.

Often it happens OnReset, in which case you can step through your reset code to find the line that prints the error.
The Following 3 Users Say Thank You to Phil BoBo For This Useful Post:
Graca Silva (11-14-2014)


Thread Thread Starter Forum Replies Last Post
About Error of "clock overflow and run stoped" syseo Q&A 1 07-23-2012 03:45 AM
How can you have a visual tool that has a mixture of "protected" and "no select"? thill Q&A 1 03-13-2012 12:44 AM
"Generate full Report" causing crash or error Paul Dowling Q&A 5 09-23-2010 11:04 AM
error message "Clock overflow, running stopped" Martin Kooijman Q&A 11 04-17-2008 10:29 AM
about "no select" and "show parameter window from side bar" qin tian Gripes and Goodies 3 03-21-2008 08:10 AM


All times are GMT -6.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.