ATTENTION

This FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices.


flexsim.com

Go Back   FlexSim Community Forum > FlexSim Software > Q&A
FAQ Downloads Calendar Search Mark Forums Read

Q&A Using Flexsim and building models

Reply
 
Thread Tools Display Modes
  #1  
Old 07-26-2008
David Chan David Chan is offline
Flexsim Distributor
 
Join Date: Sep 2007
Posts: 326
Downloads: 74
Uploads: 0
Thanks: 217
Thanked 73 Times in 44 Posts
Rep Power: 214
David Chan has a spectacular aura aboutDavid Chan has a spectacular aura aboutDavid Chan has a spectacular aura about
Default Fluid model:

Hi

I would like to model the following situation with the fluid object.

150kg of the fluid material entered into a mixer and the mixing process takes about 60min. After which the material is discharged into a tank which is 50 kg each. However, the discharge took place only once every 3 days. Therefore the material will not be able to entered into mixer until the material is discharged.

How do I model this?

Thanks

David
__________________
Advent2 Labs
David
Reply With Quote
  #2  
Old 07-26-2008
Goksin Yilmaz's Avatar
Goksin Yilmaz Goksin Yilmaz is offline
Flexsim User
 
Join Date: Aug 2007
Location: ON, Canada
Posts: 21
Downloads: 11
Uploads: 0
Thanks: 23
Thanked 13 Times in 6 Posts
Rep Power: 209
Goksin Yilmaz is a jewel in the roughGoksin Yilmaz is a jewel in the roughGoksin Yilmaz is a jewel in the rough
Default Re: Fluid Model

Hello,

I don't think I understood the question clearly, but it sounds like this could work:
  • "OnReset", close the output port(s) of the 50-kg tank.
  • "OnFull" trigger, also close the input port of the same tank.
  • In addition, "OnFull" make the tank to send a message (or messages) to itself (3 days later? etc.) and set the "OnMessage" trigger to open the appropriate ports (depending on the message parameters.)
Again, there might be a problem the way I understood the question, but hopefully this helps.

Good luck, GY

Last edited by Goksin Yilmaz; 07-26-2008 at 07:46 PM. Reason: Change from "50-gallon" to "50-kg"
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Simulati report for model with Fluid object David Chan Q&A 1 07-26-2008 03:42 AM
Fluid model Liu Bin Q&A 1 07-18-2008 02:27 AM
Fluid Blender tsconcept Q&A 4 09-13-2007 12:39 AM


All times are GMT -6. The time now is 06:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 1993-2018 FlexSim Software Products, Inc.